Pest Armor™ 1/4" Woven High Profile Z-Mesh

Free shipping to the lower 48 states!

Pest Armor’s architectural steel exclusion Z-Mesh offers tremendous versatility when faced with unique exclusion challenges. Pest Armor provides a great exclusion solution for skylights, solar panels, roof vents, soffit and siding gaps, and much more! Pest Armor 48” lengths are easy-to-handle and to ship. Durable black powder coat finish.

High Profile has a 1 1/8" Rise.  You will receive 40 - 48" pieces, for a total of 160' linear feet.

 

•  
• ¼” Woven Mesh Excludes Stinkbugs and Stinging Insects
•  
• 48” Lengths are Easy-to-Handle and Ship
•  
• Clean and Professional Appearance
•  
• Black Hex Head Screws and Sealing Washers Included
•  
• Durable Black Powder Coat Finish
•  
• Made in the USA
•  
• 7-Year Limited Warranty
•  

INSTALLING PEST ARMOR™ ON OFFSET SURFACES
› Lay out sections of Pest Armor along the offset surface.
› Install each section of Pest Armor by applying downward pressure to the bottom tab, while pushing up towards the second
surface. Secure the bottom tab every 12”, using neoprene-washered screws (included), keeping the Pest Armor tight to both
surfaces.
› Overlap all seams 1”. Paint all edges cut during installation to seal Pest Armor™, protecting it from rust and corrosion.

TURNING PEST ARMOR™ 90° ON OFFSET SURFACES
› At the point of your desired 90° turn, make 1 relief cut on the top tab of your Pest Armor. Bend the Pest Armor 90° to meet the
offset surface.
› Flatten and secure the top tab as needed. Secure the bottom tab every 12” using neoprene-washered screws (included).
› If necessary, add relief cuts to the bottom and middle tab to allow Pest Armor to flex for compounding angles (such as a roof ridge
vent end cap). Start in the middle of the end cap for the first relief cut and then add one relief cut on each side, approximately 1”
from the center cut. Add more cuts as necessary. Paint all edges cut during installation to seal Pest Armor™.​